Ignition repair in Vancouver
Key will not turn, or turns and nothing happens? We find out why.
Shop in Kitsilano
Talk to a
real locksmith
What does it do? Pick the closest.
Common ignition calls, and what we do.
The key needs jiggling to turn.
We check the key, then the cylinder wafers.
Worn cylinder 02The key snapped in the ignition.
We extract it whole and cut a new key.
Broken key 03The key turns but it will not start.
We test the switch behind the cylinder.
Switch 04The key will not come out.
We free the cylinder and test every position.
Stuck key 05The steering wheel is locked.
We free the steering lock and test the key.
Steering lockBook a locksmith in Vancouver
Book online in three quick steps, or call the shop.
- Your detailsYour name and phone. Not sure what you need? Tick phone consultation and we'll call you.
- Service & timePick the service and a time that suits you, or a time for our call.
- ConfirmEmail, address and notes. Add photos, a voice note or a PDF if it helps.
About ignitions
Three causes
- A worn key.
- A worn cylinder.
- A failed switch behind the cylinder.
A key that opens the doors but not the ignition points to the cylinder.
What it means
- Needs jiggling: worn wafers, or a copy of a copy.
- Turns, no start: the switch, not the lock.
- Cuts out over bumps: a loose switch. Get it checked soon.
- Will not come out: stuck in accessory or in the lock.
What we do
- 01Try the cheap fixes: a new key, a cleaned cylinder, a steering lock reset.
- 02Rekey or replace a worn cylinder to match your key.
- 03Replace a failed switch and re-pair the key if the car needs it.
We test accessory, on and start before we leave.
Push-start cars
- No key slot, so a no-start is often the fob or its battery.
- Then a flat car battery or a module.
- We check before selling you a key.
See key fob replacement.
By make
- Older Honda and Acura: worn wafers, key seizes half turned.
- Ford and Lincoln: column switches fail.
- GM: the lock housing often comes apart to reach the switch.
- Chrysler, Dodge, Jeep, Ram: usually a worn cylinder.
Before you call
- Turn the wheel side to side as you turn the key. A loaded steering lock is a free fix.
- Do not force the key or spray the cylinder.
- Tell us if the key turns and if the dash lights come on.
Cost and where
- Priced after we look, because one symptom can be a key or a switch.
- The $75 service call covers the visit and diagnosis in standard hours.
- A new key: $180-$280 transponder, $280-$420 smart.
Mobile locksmith service 24 hours a day, 7 days a week. Walk-in shop at 4105 Macdonald St open Monday to Friday, 8:30am to 5pm, weekends by appointment.
Questions, answered.
Still unsure? Call 604-734-7233. A real person picks up.
My key will not turn. Is it the key or the ignition?
If it works the doors but not the ignition, suspect the cylinder. We check the key first.
My key turns but the car will not start. Why?
With no dash lights and no crank, the switch behind the cylinder is the usual cause.
Can you remove a broken key?
Yes, in most cases whole. Do not push the broken half in further.
Do I have to replace the whole ignition?
Not usually. A key, cylinder or switch each has a smaller fix.
Will my key still work afterwards?
Yes. We match a rekeyed or replaced cylinder to your key.